Skip to Content

Welcome!

This community is for professionals and enthusiasts of our products and services. Share and discuss the best content and new marketing ideas, build your professional profile and become a better marketer together.

Hide Intro Register
This question has been flagged
M-DuinoSerialUSB
1 Reply
4829 Views
Avatar
Guest

I'm trying to drive an USB device with my MDuino PLC... For doing that i have tried to connect my USB cable like a serial connection.

I have connected the USB Data+ on the Serial RX while the USB Data- is on the Serial TX. Is this the way to do it? 

Avatar
Discard
Avatar
Marti Guillem Cura
Best Answer

In order to achieve this communication, you need to connect the USB wiring:
USB data- on TX1, USB data+ on RX1 and finally the GND wire to the PLC to have the same GND reference (Usially is the black wire).

Then check that Serial1 is activated on the Switch configuration pins, TX1 and RX1 at OFF position (check the user manual if you don't find them).

After setting the PLC with this connections and having it connected (12/24 Vdc), it must work for your requirements,

Thank you very much for contacting us.

Avatar
Discard
Related Posts Replies Views Activity
53RRA+ Serial communication with Linux host using a dedicated power supply
M-Duino RS232 Serial USB
Avatar
Avatar
2
Apr 21
3140
Serial communication M-Duino 38R+ with softwareSerial
M-Duino Serial
Avatar
Avatar
2
Aug 21
3214
ESP32 38AR TTL Serial
PLC Serial
Avatar
Avatar
1
Jul 23
2540
M-Duino 42+ Retrive name of pins from Arduino number
Arduino M-Duino
Avatar
Avatar
1
Aug 20
3053
5V Digital input doesn't work properly
M-Duino DigitalInput
Avatar
Avatar
1
Jun 20
3413