Labview and M-Duino

How to program M-Duino with Labview
April 26, 2019 by
Labview and M-Duino
Serzh Ohanyan

Introduction

In this post, we will show you how to program an M-Duino with an Arduino Labview block diagram. The next steps can be applied to any case.
As M-Duino is based on Arduino Mega, the way to load a program to Arduino Mega is the same for M-Duino.


Requirements

Labview Program

M-Duino   family


Step by step

Step 1: When you want to load the program to M-Duino (Arduino Mega), go to Tools -> MakerHub -> LINX -> LINX Firmware Wizard... 




Will open the next window. Step 2: In Device Family we have to choose Arduino.


Step 3: We have to select our board, Arduino Mega2560 for M-Duino. 



Step 4: We have to set the Upload Method, Serial/USB, as always.



Click Next. Step 5: Select the USB port where the board (M-Duino) is connected. 



Click Next and Next. Then the upload will start. 

​Search in our Blog

Labview and M-Duino
Serzh Ohanyan April 26, 2019

Looking for your ideal Programmable Logic Controller?

Take a look at this product comparison with other industrial controllers Arduino-based. 

We are comparing inputs, outputs, communications and other features with the ones of the relevant brands.


Industrial PLC comparison >>>