Hi,
I'm using the PLC ARBBOX PLC 20 I/O/s relay HF.
Can i use 5V input signal as interrupt input?
If it is possible, should i tune ON/OFF the DIP Switch for SDL/IO.0 ?
Thanks in advance.
Simon
Welcome!
This community is for professionals and enthusiasts of our products and services. Share and discuss the best content and new marketing ideas, build your professional profile and become a better marketer together.
Esta pregunta ha sido marcada
1
Responder
3815
Vistas
Hi,
Yes, you could use the I0.0 input as interrupt and it is necessary to switch the DIP ON abling the I0.0 configuration instead of SDL.
On the other hand you could also connect the 5Vdc signal directly at the SDL pin available on the Ardbox Relay PLC which is the same you could connect on The Arduino Leonardo board. (Important: if you use SDL pin you can not connect a higher voltage than 5Vdc).
See an example of use at the technical features link:
¿Le interesa esta conversación? ¡Participe en ella!
Cree una cuenta para poder utilizar funciones exclusivas e interactuar con la comunidad.
Inscribirse