Introducción
En este post se muestra lo básico para trabajar con GPRS SIMCOM SIM900 quad band GSM shield totalmente compatible con Arduino.Â
Requisitos
Ethernet o 20 I/Os PLC:Â Â Â Â Ethernet PLCÂ Â Â 20 I/Os PLCÂ Â Â Â
Placas de Industrial Shields:Â Â Placas de Industrial Shields:Â Â
GPRS SIMCOM SIM900 quad band GSM Shield
Especificaciones
Este shield tiene las siguientes caracterÃsticas:
- Quad-Band 850/900/1800/1900MHz
- GPRS multi-slot class 10/8
- GPRS mobile station class B
- Compliant to GSM phase 2/2+
- Class 4 (2W@850/900MHz)
- Class 1 (1W@1800/1900MHz)
- Control mediante comandos (GSM 07.07, 07.05 y SIMCOM enhanced ATcomandos)
- Servicio de mensajes cortos
- Selección de puerto serie libre
- 3.5 inch standard sonic sockets for MIC and phone
- Temperatura de funcionamiento: -40℃ ~ +85℃
Â
Los pines del shield son los siguientes:
Interfaz | Pin | Descripción |
Reset | 1 | Reset hte SIM900 module |
P | 2 | Power Switch pin of SIM900 module |
Tx | 3 | UART data in |
Rx | 4 | UART data out |
DT | 5 | Debug UART data output |
DR | 6 | Debug -UART data input |
– | 7 | GND |
+ | 8 | VCC |
Â
Implementación
Para conectar esta pantalla con nuestros productos, sólo tienes que conectar Rx y Tx a una interfaz RX/TX de nuestros dispositivos. También necesitas conectar el GND al GND del PLC. Lo último es alimentar VCC que este shield se alimenta con 5V. Se puede utilizar para la salida de 5V del PLC. Para configurar el shield ahora sólo depende del software.Â
Si usas una fuente de alimentación externa tienes que tener en cuenta que necesitas conectar el GND para tener un GND común para la fuente, el PLC y la pantalla.Â
Se dejará un enlace para ver un sencillo tutorial y cómo se hace la parte del software:
https://arduino-kit.ru/userfiles/image/GSM-shield-datasheet-Arduino-tutorial.pdf
Â
Arduino GPRS SimCom - Sim900 - quadband - GMS Shield