Forum Controladores/PLC

Welcome!

This community is for professionals and enthusiasts of our products and services. Share and discuss the best content and new marketing ideas, build your professional profile and become a better marketer together.

0

53RRA+ Serial communication with Linux host using a dedicated power supply

Avatar
Idan Sheinberg

 I wish to power my M-Duino using an external power supply (24V) and enable serial port communication from my Linux Host to the M-Duino (The Linux Side is Connected using  a USB cable)

I have a USB <-> four wire cable (Power/GND/RX/TX). Where exactly should I connect (and which wires) in order to achieve this functionality? Do I need a separate USB to RS232 adapter?

10x

Avatar
Descartar
2 Respuestas
1
Mejor respuesta

In order to properly work with our industrial PLCs the device must be powered with an external power supply from 12 to 24 Vdc. In order to achieve a Serial connection, you can use the Serial1 (Rx1 & Tx1) or the RS232 pins. If you are using a USB protocol, you should connect the Ground to one of the GND pins of the device, the Vcc to a 5Vdc output pin and the Tx & Rx to the Serial pins depending on the option that you have.


Take in mind that if you need an USB-TTL you need to work using the Serial1. If you are working with an USB-RS232 adapter, you will need to connect to the RS232 pins. We offer a USB-RS232 compatible with our devices!

Avatar
Descartar
0
Avatar
Idan Sheinberg
Mejor respuesta

Thank you very much. I will check that out.

Avatar
Descartar