Welcome!

This community is for professionals and enthusiasts of our products and services. Share and discuss the best content and new marketing ideas, build your professional profile and become a better marketer together.

0

M-Duino PLUS version RTC configuration

By
Guest
on 7/16/18, 10:43 AM 332 views

Hello,

I am trying to work with the internal RTC that provides the PLC. I would like to know if I need to configure some of the hardware to enable the RTC.

Thanks a lot Industrial Shields,


0

Alejandro Jabalquinto

--Alejandro Jabalquinto--

1000000016
| 0 0 0
--Alejandro Jabalquinto--
Alejandro Jabalquinto
On 7/16/18, 11:02 AM

Hello,

To enable the RTC of the Ethernet PLCs is necessary to configure 2 switches located in the left bottom zone. These switches are named: RTC SCL & RTC SDA. These switches must be in ON position to enable the I2C to arrive to the RTC. Take in consideration that if the RTC wants to be used, the I2C cannot be used as usual because it can enter to the RTC conflicting data that will modify all the parameters of the RTC

  • Flag

Thank you very much,

Guest
on 7/16/18, 11:03 AM

Keep Informed

About This Community

This community is for professionals and enthusiasts of our products and services. Share and discuss the best content and new marketing ideas, build your professional profile and become a better marketer together. Read Guidelines

Question tools

3 follower(s)

Stats

Asked: 7/16/18, 10:43 AM
Seen: 332 times
Last updated: 12/5/18, 1:51 PM