I would like to know how do I configure my Ethernet PLC (M-Duino 38AR+) to work with the RS232 communication protocol.
The RS232 communication protocol is enabled by default in our Ethernet PLCs. The pins RX & TX of the RS232 are located in the bottom shield and they are specified with the word RS232.
To consult the software programation you can go to the following link of our forum:
About This Community
|Asked: 7/16/18, 10:31 AM|
|Seen: 155 times|
|Last updated: 12/5/18, 1:51 PM|