I would like to know if I have to configure the Ethernet PLC to work with the Ethernet chip. I would like to know aswell which is the pin related to the Chip Select of the Ethernet chip.
thanks in advance,
The Ethernet is enabled by default. There is no hardware configuration that enables/disables the Ethernet communication. The pin related to the chip select is the pin 53 of the Arduino Mega. If you use our boards there is no need on working with the pin 53 as the library does it automatically.
About This Community
|Asked: 7/16/18, 11:12 AM|
|Seen: 290 times|
|Last updated: 12/5/18, 1:50 PM|