Labview and M-Duino/Ardbox
How to program M-Duino/Ardbox with Labview
26 April, 2019 by
Labview and M-Duino/Ardbox
Serzh Ohanyan

Introduction

In this post, we will show you how to program an M-Duino or Ardbox with an Arduino Labview block diagram. The next steps can be applied to any case.
As M-Duino is based on Arduino Mega and Ardbox on Arduino Leonardo, the way to load a program to Arduino Mega or Leonardo is the same for M-Duino or Ardbox respectively.


Requirements

Labview Program

M-Duino or Ardbox family


Step by step

Step 1: When you want to load the program to M-Duino (Arduino Mega) or Ardbox (Arduino Leonardo), go to Tools -> MakerHub -> LINX -> LINX Firmware Wizard... 




Will open the next window. Step 2: In Device Family we have to choose Arduino.


Step 3: We have to select our board, Arduino Mega2560 for M-Duino and Arduino Leonardo for Ardbox.